LoPro^®Go underfloor heating

LoPro^®Go is a dry-fit, super-low-profile underfloor heating system designed for fast, hassle-free retrofit installation. Built to lay directly over solid or suspended timber subfloors, it’s engineered to make UFH installation quick and easy, without the need for specialist tools or renovator’s compound, making it low mess and completely dry.

At just 18mm thick, this low profile UFH system is one of the slimmest overlay systems on the market, minimising build-up to floor height so doorways, stair and ceiling heights are rarely an issue, even in tight renovation projects.

LoPro^®Go is engineered to be tile-direct, meaning tiles can be laid straight onto the panel with no additional decoupling membrane or overlay boards required, saving time and cost on site as well as additional height build-up.

Combined with a fast response time, LoPro^®Go is built to provide the quick, efficient heat-up you expect from a modern renovation – whether powered by a boiler or heat pump.

LoPro^®Go has been developed specifically for easy installation into renovations. 

Step 1. Prep the floor by levelling any uneven concrete, insulating below joisted floors and priming the surface ready for the panels.

Step 2. Fix one panel with either screws or tile adhesive to the floor in a corner of the room, with the the return bends up against the wall.

Step 3. Lay the next panel, ensuring you line up the grooves in the panel with those of the first panel. Then continue to lay the first row of panels using short lengths of pipe to help with panel alignment. Panels can be cut using a sharp knife and a metal ruler or a saw.

Step 4. To return the pipe at the end of the LoPro^®Go panels back into the room, simply cut the fleece covering the bends with a sharp knife to access the required channel to continue the circuit.